Guaranteed Accomplishment with Newest Mar-2022 FREE Cisco 300-510
Use Valid New Free 300-510 Exam Dumps & Answers
NEW QUESTION 46
Which statement about enabling segment routing for IGPs is true?
- A. Segment routing must first be enabled under then routing process and then globally
- B. Segment routing can be enabled only under the routing process
- C. Segment routing must first be enabled globally and then under the routing process
- D. Segment routing can be enabled only globally
Answer: C
Explanation:
Reference:
book/sr-ospfv2-node-sid.html
NEW QUESTION 47
Refer to the exhibit.
An engineer applied the configuration on R1 to prevent network 192.168.1.0/24 from being propagated outside of area 5. After the change, users have reported they are not able to access any of the application servers that were working before. While checking the routing table of the peer router. The engineer notices R1 stopped propagating any routes outside are 5. Which action must be taken to fix the problem?
- A. Configure an additional filter-list on R1 for inbound traffic to allow external router into area 5.
- B. Add a permit statement for 0.0.0.0/0 le 32 to the end of the prefix-list 10 override the implicit deny.
- C. Reconfigure the filter-list statement to apply in the inbound direction
- D. Change the prefix-list action to permit and add an explicit deny statement for network 192.168.1.0/24
Answer: B
NEW QUESTION 48
Refer to the exhibit.
Router 1 is a core ABR in a Cisco Unified MPLS environment. All of the router 1 BGP peers are established, but traffic between customers is failing. Which BGP configuration must be added to the configuration?
- A. It must be configured with a route reflector
- B. It must be configured with send labels
- C. It must be configured for graceful restart
- D. It must be configured with PIC edge
Answer: B
NEW QUESTION 49
You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up.
Which task do you perform to begin troubleshooting the problem?
- A. Verify that multicast has been disabled globally
- B. Verify that both source interfaces are reachable from both peers
- C. Verify that PIM-DM is configured on the source interface
- D. Verify that the two MSDP peers allow asymmetric routing
Answer: B
NEW QUESTION 50
Refer to the exhibit.
Which tree does multicast traffic follow?
- A. source tree
- B. MDT default
- C. shared tree
- D. MDT voice
Answer: B
NEW QUESTION 51
Refer to the exhibit.
XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A. Option C
- B. Option B
- C. Option A
- D. Option D
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-1/routing/command/reference/ b_routing_cr41crs/b_routing_cr41crs_chapter_01000.html#wp3850885229
NEW QUESTION 52
Which cost is the default when redistributing routes from BGP to OSPF?
- A. 0
- B. infinite
- C. automatic
- D. 1
Answer: D
NEW QUESTION 53 
Refer to the exhibit. Which task must you perform on interface g1/0/0 to complete the SSM implementation?
- A. disable IGMP
- B. configure OSPFv3
- C. enable CDP
- D. configure IGMPv3
Answer: D
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-16/imc-pim-xe-16- book/imc-ssm.html
NEW QUESTION 54
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?
- A. Change HMAC-MD5 to MD5
- B. Change HMAC-MD5 to HMAC-SHA1-12
- C. Configure the send and accept lifetime under key 1
- D. Change HMAC-MD5 to HMAC-SHA1-20
Answer: C
NEW QUESTION 55
Refer to the exhibit.
Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?
- A. Router 2 must have a tunnel interface created with router 1 as the destination
- B. Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
- C. Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
- D. Router 1 must define an explicit path to router 2
Answer: C
NEW QUESTION 56
A network engineer is troubleshooting OSPF multiarea. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?
- A. DR support for topology management
- B. hierarchical CLI
- C. show ip ospf topology command
- D. routing process enabled by default on all interfaces
Answer: B
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/xr12000/software/xr12k_r4-0/routing/configuration/ guide/rc40xr12k_chapter4.html#con_1059437
NEW QUESTION 57
Refer to the exhibit.
Router 1 is connected to router 2 on interface TenGigE0/1. Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?
- A. A primary path must be manually installed
- B. TenGigE0/2 interface provides the alternate path
- C. TenGigE0/1 interface provides the alternate path
- D. A backup path must be statically installed
Answer: B
NEW QUESTION 58
Refer to the exhibit.
Which tree does multicast traffic follow?
- A. source tree
- B. MDT default
- C. shared tree
- D. MDT voice
Answer: B
NEW QUESTION 59
Which two statements about route reflectors are true? (Choose two.)
- A. Routes received from nonclient peers are reflected to route reflector clients as well as nonclient peers.
- B. If a route reflector receives a route with a cluster-list attribute containing a different cluster ID, the route is discarded.
- C. If a router received an iBGP route with the originator-ID attribute set to its own router ID, the route is discarded.
- D. Routes received from nonclient peers are reflected to route reflector cluster as well as OSPF peers.
- E. Routes received from a route reflector client is reflected to other clients and nonclient peers.
Answer: C,E
Explanation:
Explanation/Reference: http://www.networkers-online.com/blog/2009/02/bgp-route-reflector-basics/
NEW QUESTION 60
What are two differences between OSPF and IS-IS? (Choose two.)
- A. OSPF elects a DR and a BDR, and IS-IS elects a DIS.
- B. OSPF is a link-state routing protocol, and IS-IS is a distance-vector routing protocol.
- C. OSPF uses a router ID to identify a router, and IS-IS uses a system ID.
- D. Unlike IS-IS routers, an OSPF router belongs to only one area in addition to the backbone area.
- E. Unlike OSPF. IS-IS supports virtual links.
Answer: A,C
NEW QUESTION 61
Refer to the exhibit.
An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?
- A. The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.
- B. The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.
- C. The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.
- D. The MED attribute can be applied on R2 to influence R1 to use it as the primary path.
Answer: B
NEW QUESTION 62
Refer to the exhibit.
An administrator is troubleshooting Internet access issues on a customer's network. After applying this ISIS configuration to R1, the administrator notices that it fails to redistribute the default route into IS-IS. After checking the connectivity between the ISIS router and the ISP router the engineer confirmed there is Layer 3 connectivity between them Which action should be taken to correct the problem?
- A. Add the default-information originate command to the configuration
- B. Configure the default route under any routing protocol other than IS-IS
- C. Configure R1 as a Layer 1 router
- D. Associate the default route with a VRF
Answer: A
NEW QUESTION 63
What can be used to determine a path from the head-end to a tail-end router when implementing SR-TE with a head-end, with little information on the network topology?
- A. path computation engine
- B. traffic controller
- C. tail-end router
- D. SNMP server
Answer: A
NEW QUESTION 64
......
More about 300-510 Exam
If you target the CCNP Service Provider, the Cisco 300-510 test comes second after 350-501 exam, normally called the core validation. 300-510 test, on the other hand, is among two other concentration tests, namely, the Cisco 300-515 and 300-535. To add more, 300-510 exam is into topics like routing protocols, MPLS, segment routing, and policy language. The duration set aside for it is 1.5 hours and the amount to pay during registration is $300. Sadly, Cisco does not give any report regarding the least score that takers of this test should get for the sake of becoming certified. So, striving for high marks should be your aim. However, in case your attempt is not successful the first time, there is a chance to redo the test once five days have elapsed from the date you attempted it.
The best audience for exam 300-510 include network administrators, network designers, project managers, and system engineers, among other specialists.
300-510 Braindumps PDF, Cisco 300-510 Exam Cram: https://www.examtorrent.com/300-510-valid-vce-dumps.html
New 2022 300-510 Sample Questions Reliable 300-510 Test Engine: https://drive.google.com/open?id=1Iw5zpNupWA2zDtUN9qtlibnGxKnDdCho
