Updated Jan 05, 2024 Verified CWDP-304 dumps Q&As - 100% Pass
New 2024 Latest Questions CWDP-304 Dumps - Use Updated CWNP Exam
NEW QUESTION # 53
What service must be implemented on your customers' network to authenticate users against an LDAP database prior to access to the WLAN infrastructure being granted?
- A. TLS
- B. RADIUS
- C. SFTP
- D. NTP
Answer: B
NEW QUESTION # 54
When you see the SKINNY protocol in a post-install validation protocol capture, what does this indicate?
Response:
- A. Multicasting is used on the network
- B. HTTPS is in use
- C. Secure FTP is in use
- D. VoIP is used on the network
Answer: D
NEW QUESTION # 55
What limitation exists when WMM is not enabled on an 802.11n WLAN?
Response:
- A. EDCA values will change
- B. Only two ACs will be available
- C. 802.11 QoS will not be available
- D. The maximum channel-width will be 20MHz
Answer: C
NEW QUESTION # 56
What metric implements the simplest algorithm and lowest accuracy in networks requiring locations?
Response:
- A. Time Difference of Arrival (TDoA)
- B. Angle of Arrival (AoA)
- C. Time of Arrival (ToA)
- D. Received Signal Strength Indicator (RSSI)
Answer: D
NEW QUESTION # 57
Switches and APs have already been chosen by your customer. All switches support 802.3bz MultiGig interfaces and APs are 4x4:4 802.11ac wave 2 capable of using dual-5GHz and have one MultiGig interface. Some cable drops for the APs will run for more than 180.5 feet (or 55 meters). To support MultiGig, what is the best choice of cabling?
- A. Cat-6
- B. Cat-6a
- C. Cat-5e
- D. Cat-5
Answer: B
NEW QUESTION # 58
You are on site, planning a network at a freight shipping company on a busy harbor. Since the preliminary WLAN design specifies support for the 5 GHz spectrum, you would like to test for radar pulses to determine if DFS channels should be supported at this facility. As a part of your spectral survey with a laptop-based analyzer, you include DFS testing to identify the presence of radar. This is done by manually observing Real-time FFT, Duty Cycle, and Active Devices charts of the spectrum analyzer software.
What potential drawback is present with this DFS test method?
- A. Some sources of 5 GHz radar, such as military ships, are mobile in nature. A longer, automated test setup should be used to identify the presence or absence of radar.
- B. Many WLAN products that support DFS channels report several false positives. Ideally, the actual WLAN equipment used in the deployment should be used to test for DFS.
- C. Modern spectrum analyzer adapters do not provide the necessary bandwidth resolution required to detect and measure radar signatures.
- D. Manual identification of radar pulses using spectrum analysis charts can be very difficult due to radar's low amplitude at the Wi-Fi receiver.
Answer: D
NEW QUESTION # 59
During a validation site survey, you realize that the installers mounted some of the APs above the ceiling.
They said that this was a request from
the building architect due to aesthetics constraints. During the requirements gathering, you weren't advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?
- A. Remove all external antennas and use only the internal antennas to reduce multipath.
- B. Leave it as it is and allow automatic channel management to correct any issues.
- C. Advise the stakeholder that WLAN performance requirements will not be met and a new design process will be needed to meet the requirements.
- D. Increase the output power on all APs by 6 dB immediately.
Answer: C
NEW QUESTION # 60
Four buildings are located in a square orientation to each other. Fisch Stix Food Company is requesting a PtMP link between the buildings. On the building with the root bridge link, what type of antenna is the best choice?
Response:
- A. Vertically polarized omni
- B. 60° yagi
- C. 100° sector
- D. Parabolic dish
- E. Horizontally polarized omni
Answer: C
NEW QUESTION # 61
The thermal noise is at 174 dBm/Hz. A spectrum analyzer has a resolution bandwidth of 1 kHz and a 5 dB noise figure. What is the level of the noise floor?
Response:
- A. 174 dBm
- B. 204 dBm
- C. 144 dBm
- D. 139 dBm
Answer: D
NEW QUESTION # 62
As an implementation engineer, you have just received initial design specs from a network designer for your dual-band 802.11n deployment. The network design documents prescribe the following data rate configuration for the 2.4 GHz radio:
Basic Rates 5.5, 6, 11, 12 Mbps
Supported Rates 9, 18, 24, 36, 48, and 54 Mbps as well as MCS 0-15
What will result from this design strategy?
- A. By disabling support for 1 and 2 Mbps while allowing 5.5 and 11 Mbps, the network will force 802.11b clients to use these higher data rates.
- B. HR/DSSS (802.11b) stations will not be able to associate to the service set.
- C. This configuration violates the IEEE specification that defines 6, 12, and 24 Mbps as mandatory data rates for 802.11g/n.
- D. Protection mechanisms will always be in use on this network to support 5.5 and 11 Mbps as basic rates.
Answer: A
NEW QUESTION # 63
In a PC-based spectrum analyzer, what data chart identifies the overall RF utilization of a specific frequency in the environment being surveyed?
- A. Duty cycle
- B. Swept Spectrogram
- C. FFT Average
- D. FFT Max Hold
Answer: B
NEW QUESTION # 64
If radar has reportedly been detected on your WLAN deployment, what bands would you consider avoiding?
Response:
- A. 5 GHz UNII-1, 2, and 3
- B. 5 GHz UNII-1 and 2
- C. 5 GHz UNII-2, 2e, and 3
- D. 5 GHz UNII-2 and 2e
- E. 5 GHz UNII-2 and 3
Answer: D
NEW QUESTION # 65
When implementing WLAN security according to common best practices, what feature should be enabled when configuring an EAP type?
Response:
- A. The "Do not prompt user to authorize new servers or trusted certification authorities" option
- B. The "Trusted Root Certification Authorities" list
- C. The "Use WEP if RADIUS server unavailable" option
- D. The "Validate server certificate" option
Answer: D
NEW QUESTION # 66
A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?
Response:
- A. Use an 802.11b AP, so it looks old enough to be in a museum
- B. Place the APs in between walls and I-beams
- C. Use a plastic cover that could blend in with the environment
- D. Lock the AP inside of a metal box
Answer: C
NEW QUESTION # 67
You desire to achieve a 450 Mbps MCS. What 802.11n features (from the numbered list below) are required?
1. Frame aggregation
2. Short GI
3. 40 MHz channels
4. 2 spatial streams
5. 3 spatial streams
6. Transmit beamforming (TxBF)
- A. 1, 2, 3, 5
- B. 2, 3, 5
- C. 2, 3, 2
- D. 1, 2, 3, 4, 6
Answer: B
NEW QUESTION # 68
What is the DSCP Per Hop Behavior equivalent classification of the 802.11 AC_VO priority level?
- A. VO
- B. AF31
- C. EF
- D. CS3
Answer: C
NEW QUESTION # 69
Why should band steering algorithms allow stations to connect to the 2.4 GHz band after some number of ignored Probe Requests?
- A. Because the FCC requires it.
- B. Because the 802.11 standard requires it.
- C. Because some clients are persistent clients that will not move on to the 5 GHz band.
- D. Because the AP will experience a buffer overflow if they do not eventually respond with a Probe Response.
Answer: C
NEW QUESTION # 70
During lunch time in the break room of a company, Wi-Fi connectivity on the 2.4 GHz band is intermittent.
Every other time of the day, it works fine.
What's the likely cause of this issue?
- A. Microwaves in the cafeteria are interfering with the Wi-Fi on the 2.4 GHz band
- B. Toasters and ovens are heating up the air, raising the noise floor with the Wi-Fi on the 2.4 Ghz band
- C. The AP in the cafeteria keeps rebooting due to lack of PoE budget on the switch
- D. Employees are using their cell data instead of using the Wi-Fi
Answer: A
NEW QUESTION # 71
When deploying APs outdoors, what additional component needs to be used that is not needed indoors?
- A. Ethernet cables
- B. PoE
- C. Antennas
- D. NEMA enclosures
Answer: D
NEW QUESTION # 72
Which definition correctly describes the "local MAC" variation of the centralized WLAN architecture?
- A. PHY functions are performed directly by the AP. MAC functions are divided almost equally between the WLAN controller and the AP, according to the time sensitivity of the feature or service.
- B. The AP provides the RF termination point for the WLAN, but performs very few of the WLAN functions or services. The WLAN controller performs all MAC functions and the AP is very simple and lightweight.
- C. All RF-, data-, and control-related WLAN functions are performed by the AP. APs coordinate network services with one another and are managed by a WNMS,
- D. All MAC functions are performed by the AP. A minimal subset of network control is offloaded to the WLAN controller along with management and monitoring functions.
Answer: D
NEW QUESTION # 73
A table of VLANs in a _________ document should include what device performs ________ services.(Fill in the blanks)
- A. HLD, routing
- B. HLD, QoS
- C. LLD, bridging
- D. LLD, routing
Answer: D
NEW QUESTION # 74
......
CWNP CWDP-304 Exam Certification Details:
| Exam Price | $275 USD |
| Passing Score | 70% |
| Exam Code | CWDP-304 CWDP |
| Duration | 90 minutes |
| Exam Name | Wireless Design Professional |
| Exam Registration | PEARSON VUE |
| Number of Questions | 60 |
Latest CWDP-304 Exam Dumps CWNP Exam from Training: https://www.examtorrent.com/CWDP-304-valid-vce-dumps.html
Pass CWNP CWDP-304 PDF Dumps Recently Updated 249 Questions: https://drive.google.com/open?id=1qXnJSF8PyQoW8nnzCcJ60Xo0TtfbRB5d
