Steps Necessary To Pass The 200-301 Exam from Training Expert ExamTorrent
Valid Way To Pass CCNA's 200-301 Exam
NEW QUESTION 42
Drag and Drop Question
Drag and drop the benefits of a cisco wireless Lan controller from the left onto the correct examples on the right.
Select and Place:
Answer:
Explanation:
NEW QUESTION 43
Refer to the exhibit.
An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC-2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN Which configuration meets these requirements?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 44
Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.
Answer:
Explanation:
Explanation
TCP
* Sends tranmissions in sequence
4. Transmits packets individually
6. Uses a lower transmission rate to ensure relability
UDP
5. Uses a higher transmission rate to support latency-sensitive application
2. Transmissions include an 8-byte header
3. Transmits packets as a stream
NEW QUESTION 45
How does HSRP provide first hop redundancy?
- A. It forwards multiple packets to the same destination over different routed links n the data path
- B. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
- C. It uses a shared virtual MAC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN
- D. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
Answer: C
NEW QUESTION 46
What is a difference between local AP mode and FiexConnet AP mode?
- A. Local AP mode creates two CAPWAP tunnels per AP to the WLC
- B. FlexConnect AP mode bridges the traffic from the AP to the WLC when local switching is configured
- C. Local AP mode causes the AP to behave as if it were an autonomous AP
- D. FiexConnect AP mode fails to function if me AP loses connectivity with the WLC
Answer: A
NEW QUESTION 47
Refer to the exhibit.
An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1 The new circuit uses eBGP and teams the route to VLAN25 from the BGP path What s the expected behavior for the traffic flow for route 10.10.13.0/25?
- A. Route 10.10.13.0/25 learned via the GiO/0 interface remains in the routing table
- B. Traffic to 10.10.13.0.25 is load balanced out of multiple interfaces
- C. Traffic to 10.10.13.0/25 is asymmeteical
- D. Route 10.10.13.0/25 is updated in the routing table as being learned from interface Gi0/1.
Answer: C
NEW QUESTION 48
What are network endpoints?
- A. enforce policies for campus-wide traffic going to the internet
- B. act as routers to connect a user to the service prowler network
- C. a threat to the network if they are compromised
- D. support inter-VLAN connectivity
Answer: C
NEW QUESTION 49
Which value is indicated by the next hop in a routing table?
- A. exit interface IP address for forwarding the packets
- B. preference of the route source
- C. how the route was learned
- D. IP address of the remote router for forwarding the packets
Answer: D
NEW QUESTION 50
Which feature can you implement to reserve bandwidth for VoIP calls across the call path?
- A. round robin
- B. CBWFQ
- C. PQ
- D. RSVP
Answer: D
NEW QUESTION 51
Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.
Answer:
Explanation:
NEW QUESTION 52
An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of three addresses
192.168.30.1, 192.168.3.2, 192.168.3.3 Which configuration should be used?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 53
Refer to the exhibit.
An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the GigabitEfriemet3/1/4 port on a switch?
- A. The phone and a workstation that is connected to the phone send and receive data in VLAN 50.
- B. The phone sends and receives data in VLAN 50, but a workstation connected to the phone has no VLAN connectivity
- C. The phone sends and receives data in VLAN 50, but a workstation connected to the phone sends and receives data in VLAN 1
- D. The phone and a workstation that is connected to the phone do not have VLAN connectivity
Answer: C
NEW QUESTION 54
Refer to the exhibit.
Which type of route does R1 use to reach host 10.10.13.10/32?
- A. floating static route
- B. default route
- C. host route
- D. network route
Answer: D
NEW QUESTION 55
What is a characteristic of private IPv4 addressing?
- A. used without tracking or registration
- B. issued by IANA in conjunction with an autonomous system number
- C. traverse the Internet when an outbound ACL is applied
- D. composed of up to 65.536 available addresses
Answer: A
NEW QUESTION 56
Refer to the exhibit. If OSPF is running on this network,how does Router 2handle traffic from Site B to 10.10.13/25 at Site A?
- A. It sends packets out of interface Fa0/1 only.
- B. It sends packets out of interface Fa0/2 only.
- C. It load-balances traffic out of Fa0/1 and Fa0/2
- D. It cannot send packets to 10.10.13 128/25
Answer: D
Explanation:
Router2 does not have an entry for the subnet 10.10.13.128/25. It only has an entry for
10.10.13.0/25, which ranges from 10.10.13.0 to 10.10.13.127.
NEW QUESTION 57
Drag and drop the functions from the left onto the correct network components on the right
Answer:
Explanation:
NEW QUESTION 58
Refer to the exhibit.
With which metric was the route to host 172.16.0.202 learned?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 59
Refer to the exhibit.
If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?
- A. router
- B. DHCP client
- C. access point
- D. PC
Answer: A
NEW QUESTION 60
Refer to the exhibit.
To which device does Router1 send packets that are destined to host 10.10.13.165?
- A. Router3
- B. Router2
- C. Router5
- D. Router4
Answer: A
NEW QUESTION 61
Which command is used to enable LLDP globally on a Cisco IOS ISR?
- A. lldp run
- B. lldp enable
- C. cdp run
- D. lldp transmit
- E. cdp enable
Answer: A
Explanation:
Link Layer Discovery Protocol (LLDP) is a industry standard protocol that allows devices to advertise, and discover connected devices, and there capabilities (same as CDP of Cisco). To enable it on Cisco devices, we have to use this command under global configuration mode:
Sw(config)# lldp run
NEW QUESTION 62
Refer to the exhibit.
An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?
- A. ipv6 route 0/0 Serial 0/0/0
- B. ipv6 route ::/0 Serial 0/0/1
- C. ip route 0.0.0.0.0.0.0.0 Serial 0/0/0
- D. ipv6 route ::/0 Serial 0/0/0
- E. ipv6 route ::/0 2000::2
Answer: D
NEW QUESTION 63
Refer to the exhibit.
An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC-2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN Which configuration meets these requirements?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 64
......
Important Details of Cisco 200-301 Exam
Cisco doesn’t reveal the details of its exams beforehand, so the exact number of questions and their types are unknown. The question formats that may appear in the 200-301 test include testlets, simlets, multiple choice, and drag and drop. Note that all the questions in the exam are to be completed within the allocated time of 2 hours. To schedule this certification test, the students need to sign up with Pearson VUE and pay the registration fee of $300.
All 200-301 Dumps and Cisco Certified Network Associate Exam Training Courses: https://www.examtorrent.com/200-301-valid-vce-dumps.html
Free Test Engine For Cisco Certified Network Associate Exam Certification Exams: https://drive.google.com/open?id=1ZilFl2HKYF-hgZMWBB0EdvydfSANWEP-
